Stepstick Drv8825 Stepper Motor Driver For Reprap Prusa Mendel 3d Ramps 1.4

UMT Media
Availability: 50 In Stock
Modules / Sensor
UMT Media

Item Specifics

CONDITION: New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). If the item comes direct from a manufacturer, it may be delivered in non-retail packaging, such as a plain or unprinted box or plastic bag. See the seller's listing for full details. See all condition definitions



MPN: Does Not Apply


 This DRV8825 Stepper Motor Driver Module is upgrade of A4988. Use for replacing the A4988 to upgrade your 3D printer.
Highest support 32 subdivision.
Can interface directly with 3.3V and 5V systems.
4-layer, 2 oz copper PCB for improved heat dissipation.
Small chip resistance, with low heat and good heat radiation feature.
Built-in regulator (no external logic voltage supply needed).
Adjustable current control lets you set the maximum current output with a potentiometer, you can use voltage that is higher than the stepper motor's rated voltage to achieve higher step rates.
Intelligent chopping control, automatically selects the correct current decay mode (fast decay or slow decay).
Overheating closed circuit, under voltage lockout, cross current protection.
Grounding short circuit protection and load short circuit protection.
Exposed solderable ground pad below the driver IC on the bottom of the PCB.
Module size, pinout, and interface match those A4988 stepper motor driver carriers in most respects.

Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
Maximum Supply Voltage: 45V
Maximum Current : 2.5A
Drive Current: 2.5A
Size: 1.5mm x 2mm

UMT Computers Ltd
Unit 4 Ground Floor Meridian House,
Nazeing Glass Works Estate,
EN10 6SX
United Kingdom
VAT ID GB 700209102

Company registration number: 3446134
VAT number: GB 700209102
I provide invoices with VAT separately displayed.
Just added to your wishlist:
My Wishlist
You've just added this product to the cart:
Go to cart page